Plastic jack point is loose. Are these things supposed to be glued on?
#1
AudiWorld Junior Member
Thread Starter
Plastic jack point is loose. Are these things supposed to be glued on?
So, my car is missing one of the plastic under body jack point. Specifically, the part I'm referencing here is 4H0 802 845 B
Anyway, i bought a replacement and put the part in place but the fit is very loose. The under body panel where the plastic jack point goes into looks straight and doesn't look to be damaged in anyway. By design, it appears that a catch on the plastic jack point goes into the circular hole cut out in the under body panel.
My question is, has anybody had similar experience replacing the part? If so, any adhesive like silicone adhesive used?
Anyway, i bought a replacement and put the part in place but the fit is very loose. The under body panel where the plastic jack point goes into looks straight and doesn't look to be damaged in anyway. By design, it appears that a catch on the plastic jack point goes into the circular hole cut out in the under body panel.
My question is, has anybody had similar experience replacing the part? If so, any adhesive like silicone adhesive used?
Thread
Thread Starter
Forum
Replies
Last Post
Ming rings in Minn
A6 / S6 (C5 Platform) Discussion
19
11-14-2005 12:35 PM
allegro
S4 / RS4 (B5 Platform) Discussion
2
10-13-2005 05:14 AM
Miah_S4Avant
S4 (B6 & B7 Platforms) Discussion
10
04-15-2005 11:49 PM