Arold Jacques

Ok! The is driving but thinks it’s in park mode.
I hear no noise when I push or pull the switch. I am wondering. What died now!
got a new rear right parking motor. Do I need to get left to?
I got a new parking module switch.
but beep still teasing me and it’s loud. I ran VCDS her is the VCDS code.....
am missing something here! a fuse?

your help is greatly appreciated I will record it and post the solution on FB.

Software Coding: 0000532

Work Shop Code: WSC 25101 444 52519

VCID: 1D67D8A891BAFA13595-8048

4 Faults Found:

02435 - Supply Voltage for Control Module for Right Channel

009 - Open or Short to Ground - MIL ON

Freeze Frame:

Fault Status: 11101001

Fault Priority: 1

Fault Frequency: 10

Reset counter: 80

Mileage: 239904 km

Time Indication: 0

Date: 2004.03.25

Time: 00:07:37

Freeze Frame:

Voltage: 10.87 V

Count: 113

02596 - Rear Brake Pads Worn

008 - Implausible Signal

Freeze Frame:

Fault Status: 01101000

Fault Priority: 6

Fault Frequency: 1

Reset counter: 81

Mileage: 239904 km

Time Indication: 0

Date: 2004.03.28

Time: 03:09:23

Freeze Frame:

Voltage: 10.87 V

Count: 61

02432 - Supply Voltage for Left Parking Brake Motor (V282)

012 - Electrical Fault in Circuit - MIL ON

Freeze Frame:

Fault Status: 11111100

Fault Priority: 1

Fault Frequency: 1

Reset counter: 80

Mileage: 239904 km

Time Indication: 0

Date: 2004.03.25

Time: 04:39:05

Freeze Frame:

Voltage: 12.01 V

Count: 86

02443 - Control Head

012 - Electrical Fault in Circuit - MIL ON

Freeze Frame:

Fault Status: 11101100

Fault Priority: 2

Fault Frequency: 10

Reset counter: 80

Mileage: 239904 km

Time Indication: 0

Date: 2004.03.25

Time: 00:07:37

Freeze Frame:

Voltage: 10.87 V

Count: 45

BASARAB

Most likely parking brake motors

Arold Jacques

Will check

fjord

Both motors are identical, you can swap them and see if anything changes.

Andi Andu

Hi,

I had a similar problem before and there was no problem with the motor but with EPB ECU. I bought on eBay for 50pounds and is a simple plug and play ecu. No need for coding just swap the ecu.

Best,

Andi

Veikra

I've seen all the possible problems, salt country with a 543 000km car. Dont rule out the wiring. Look around the 1min part where the current flickers , thats indication of bad wiring.

Supply Voltage for Left Parking Brake Motor (V282) thats the power from the fuses in the quarter panel going through the motor and back on one side and module ground the other side and vice versa to retract That code is module, wiring, or caliper open circuit or frayed wires.

You can actuate calipers manually by unplugging EPB module and putting power in the pins. If it works, then module is bad. If it doesnt, wring or caliper is bad. THen you go to caliper, put power, if it moves fine, its the wiring and you'll have to do the wiring swap im doing in the video