Brozee

Mine still do not work without throwing a code. And I still havent touched throwing a resistor on it. Oh well stock it is.

williebone

Switch over to these http://hidlightsusa.com/product.asp?id=GP-194-5SMD-S. They will draw more Current than the single LED Canbus and should work in theory. I don't get the Bulb Out Warning anymore with these. Laters,

Brozee

So you have those ones in the link you just posted. And you never received a light out warning?

And would you go with the first or second one on this page?
http://hidlightsusa.com/shopping.asp...iature%20Bulbs
I'm thinking maybe the second one because all the light output is directed in one direction.

williebone

I have no experience with any other LEDs other than the 2 City Light LEDs that have been used in this Thread. I got the Warning with one but not the other and that all I know at this point. The only thing anyone can do is try something out to see and if not then send them back! Good luck & laters,

05SilverA8

I kept getting the Lights Out Error utilizing the single LED bulbs. I tried several others and found that the 5 LED SMT 10mm x 32mm for $9.99 each from ( http://autolumination.com/194.htm )worked fine. They draw enough current so that the lights out warning does not appear.

williebone

"Note" Hit Edit & Space the word "worked" so that it is not tied into the website link in your Post. Laters,

abarmard

Thanks for the post. It was very informative. On that website, (where you bought your bulbs) which one did you use? the Super white or the Blue one? Another question;
Making the left head light loose and putting it back in, would it mess with the leveling of the head lights. DO they need to be repositioned/readjusted/leveled again?
You can also reply to to my emai address;
monzavifar@hotmail.com

Thank you,
A,

Mydeskjob

Great LED conversion!!!
Did you use the 1 LED element and get that much light?
If so that is awsome, are the white or blue?

Thanks, super job!

AEinaD3

The lights are Super White/ Cool White, The camera made them look blue, but they are actually White..

abarmard

After ordering 2 different kinds of those LED lights online (As was suggested), I spent 2 hours installing them. First the 9X22mm ones, it was OK for about 10 minutes, then they started blinking like a turn signal, however the Board computer was OK with it. Then I repalced them with the 9X24mm ones, the lights worked well but the board computer threw the "Bulb out" error, finally I uninstalled them and put the old hallogens back on.
If you guys have any other suggestions, I'm all ear!!