Driver's side tail/back-up light lens replacement.
#1
Driver's side tail/back-up light lens replacement.
Does anyone know how difficult it is to replace the driver's side tail light lens(trunk portion)?
I found a crack in mine but see no visible attachment clips/screws in either the lens or the trunk lid liner. Thanks for any help.
I found a crack in mine but see no visible attachment clips/screws in either the lens or the trunk lid liner. Thanks for any help.
#3
AudiWorld Super User
Re: Remove the liner. It's behind there.
Removing
Switch off ignition and remove ignition key.
Turn light switch to "0" position.
Remove trunk lid trim
Unplug connector.
Remove nuts and detach rear light.
If necessary, pull wire with grommet out of luggage compartment lid.
Installing
Install in reverse order of removal, observing the following:
Note:
Replace adjusting nuts if sealing washer is damaged.
Check for proper sealing of grommet between luggage compartment lid and wire.
Tightening torque
Component Nm
Rear light to trunk lid 3 NM
Back-up light is an incandescent bulb in 2004 and the brake & tail lights are LED boards which are supposed to be replaced as a unit. However, some of us have sample LED's made by Stanley and can service surface mount PC boards. You can also buy the LED's cheap from Digi-Key.
Switch off ignition and remove ignition key.
Turn light switch to "0" position.
Remove trunk lid trim
Unplug connector.
Remove nuts and detach rear light.
If necessary, pull wire with grommet out of luggage compartment lid.
Installing
Install in reverse order of removal, observing the following:
Note:
Replace adjusting nuts if sealing washer is damaged.
Check for proper sealing of grommet between luggage compartment lid and wire.
Tightening torque
Component Nm
Rear light to trunk lid 3 NM
Back-up light is an incandescent bulb in 2004 and the brake & tail lights are LED boards which are supposed to be replaced as a unit. However, some of us have sample LED's made by Stanley and can service surface mount PC boards. You can also buy the LED's cheap from Digi-Key.
#6
AudiWorld Super User
Remove tool kit assembly (four or five screws under plastic discs that pop out with a screwdriver) Remove emergency handle; the screw is behind the glow in the dark cover that pops off with a screwdriver or good thumbnail. Pull handle comes off with a screw or two IIRC. Then you pry the "carpet pad" cover off with your hands with gloves or a large trim removal tool or screwdriver or putty knife. Be careful so you don't scratch any paint. It's one solid plastic piece covered with felt.
Trending Topics
#8
Remove tool kit assembly (four or five screws under plastic discs that pop out with a screwdriver) Remove emergency handle; the screw is behind the glow in the dark cover that pops off with a screwdriver or good thumbnail. Pull handle comes off with a screw or two IIRC. Then you pry the "carpet pad" cover off with your hands with gloves or a large trim removal tool or screwdriver or putty knife. Be careful so you don't scratch any paint. It's one solid plastic piece covered with felt.
Scott
Thread
Thread Starter
Forum
Replies
Last Post
paul_858
A4 (B5 Platform) Discussion
24
02-04-2003 07:04 AM