awdinut

I need to install an AMI in an A6 and I have the fiber optic cable that requires taking a plug apart to change fiber cables. I did my install so long ago I do not remember what to do with the plug, and I can not find anything with search to show me. Anyone know how ?

bmwm750

You can't "split" the fiber cable. There is a Y adapter that comes with the kit, you install this between the changer and AMI module.

mishar

Will this help?

05SilverA8

This may help also, same setup for doing the AMI:

MP4.2+6.0

for the power takeoff from the CD changer. On the optical, you extend the loop by taking one side of the optical ring away from the CD changer, essentially moving it to the "same" side of the AMI unit, and then adding the optical between the two. The wiring kit did include a fitting for the optical that did seem kind of like a "splitter," but light wise I believe it's as I describe and that piece was actually probably a coupling to enable the extension and the in-out serial connection nature of the optical loop.

awdinut

there is a connector for connecting one line from the original CD cable and one line from the new AMI cable in a straight line loop. The other AMI fiber line has to go into the CD optic plug.

awdinut

Thanks. But as I recall , the plug was difficult to take apart and get together, but I need a text telling me the steps...those two photos dont bring to mind what it is that is required. Sorry.

awdinut

Thankyou, shows me which half of the CD plug to 'loop'.

05SilverA8

if you need detailed pictures of the connectors PM me and I will forward you some if you can't figure out how to get them apart.

mishar

1. Picture:

Release locking latch in fiber optic cable connector (arrow).

2. Picture:

Release secondary latch (6) using a small screwdriver (arrow).

Release catch (2) and remove fiber optic cable (5) with brass connector pin (4) from base module (1).