ahh alright. this was a black 2.7t A6 with some nice wheels (BBS IIRC). The guy driving it looked a little like the dude on the right in the "killaz (was it?)" shot in your pic poster.

In the stable
* 2000 A6 2.7t: chipped, Miltek exhaust
* 1990 90q 20vt (in progress) Tornado Red
* 1990 90q 20v, pearl white, needs some maintenance

Replaced(failed) parts:
Lower Door Trims
New coolant expansion tank
Head, -broken drill inside broken exh. stud :\
Oil Temp Sensor
ISV(new)
Transmission (10mm deep socket fell into the bell housing ;-0)
front/Rear tierod full assemblies
4 corner Ball joints
Timing Belt
Water Pump
thermostat
Alpine 9855 Head Unit
Infinity speakers/wiring/power/ground leads
OEM O2 Sensor
Tranny mounts
Outside temp sensor
Blower motor
Fuel Pressure Regulator
MAF
Crankcase ventilation tube
several failed injectors

Misc. Repairs:
Distributor rattle fixed
Headlight Combination switch rebuilt
Repair/replaced dash switches

yet to repair:
Heater Control Valve (on the bed, can't figure out where the vacuum hose connects)
rear brakes/parking brake
Paint!!!! -Holy crap it's bad
install brake bomb (bed)
Driver F QP

"On the Bed":
B4 control arms
B4 fenders on the way
Summit Racing Batt. Relocation kit
034 - oil and water lines
Kamei front grill
RS2 emblem
3 1/2" turbo-back stainless mandrel bent exhaust, magnaflow muffler
Porsche Turbo Twists
034 high output cast manifold w/ Garrett turbo flange.
Replacement Tranny 01A, 34k miles (installed)
ClutchNet yellow, disk and pressure plate (stage 3).
Garrett GT 3071R turbo
ABT Side valences
034 EFI full IIc Spark + Ignition
550cc Bosch injectors
AAN long block
ARP Main, Head, & Rod bolts
Timing Belt, tensioner pulley
Piston rings, main bearings, rod bearings
full upper / lower seal kit, Reinz steel head gasket
new turbo gasket, studs, exhaust studs, flywheel bolts, valve cover bolts
RS2 Front Bumper replica from squidx
4 x Porsche 996 Monoblocks
RS2 Caliper Brackets (F)
Custom rear caliper brackets
Tilton valve
keyless entry
5 x 112 hub conversion parts / rotors
Spearco 20 x 10 x 3 intercooler

Yet to buy
Intake Manifold solution
IC Plumbing
RS2 Headlights
S2 bumper lights
Paint