Used ABS Control Module
#3
AudiWorld Member
Thread Starter
I have checked with MM and they said that they can rebuild it. However, in order to get the ABS controller out I must drain the brake lines and remove the ABS pump/ecu which is too much of a hassel. I would have to do the removal/instal job twice if I want to keep the car running, once to ship ECU out and once when it comes back. At this point I was wondering if could just find a good used ABS pump/ecu to do the removal/instal job once.
#4
Bummer that you can't just separate the units
The older controllers (B5/C5) could be separated fom the pump without impacting the fluid. You'd still be down a car for a few days, but at least you didn't have to mess with bleeding.
#6
AudiWorld Member
Thread Starter
#7
I have one, but there is problem with control module
4F0614517 L
18061 - Please check DTC Memory of ABS Controller
P1653 - 008 - Implausible Signal
Freeze Frame:
Fault Status: 00101000
Fault Priority: 2
Fault Frequency: 24
Reset counter: 40
Mileage: 183761 km
Time Indication: 0
Date: 2011.02.13
Time: 22:41:20
4F0614517 L
18061 - Please check DTC Memory of ABS Controller
P1653 - 008 - Implausible Signal
Freeze Frame:
Fault Status: 00101000
Fault Priority: 2
Fault Frequency: 24
Reset counter: 40
Mileage: 183761 km
Time Indication: 0
Date: 2011.02.13
Time: 22:41:20
Trending Topics
#8
AudiWorld Member
Thread Starter
Ok, so I ended up draining the brake lines with a vacuum pump and the ABS pump did drain as well. After removing the ABS pump to get to the ABS ECU I realized that there was no way in hell I was going to get the ECU without removing the pump. ECU and pump are out to Module Master today and hope for the best.
Thread
Thread Starter
Forum
Replies
Last Post
mksu19
A4 (B5 Platform) Discussion
5
06-04-2019 10:26 PM
marioec
Q7 MK 1 Discussion
1
08-30-2016 08:45 AM