Last edit by: IB Advertising
See related guides and technical advice from our community experts:
- Audi A6 C6 Oil Pressure Warning Light Diagnostic<br>Guide to diagnose trouble and recommended solution.
Oil pressure warning light question
#11
Audiworld Junior Member
Thread Starter
Join Date: Jul 2007
Posts: 25
Likes: 0
Received 0 Likes
on
0 Posts
UPDATE:
Oil change/sensor change seems to have fixed it. I ran it for 20+ minutes up and down the road watching the vagcom and 99% of the time it was ok - sensor reading ok. No warning light, got oil up to temperature, probably went about 15 miles mixed in town/highway. Everyonce in awhile looking back through the log it was reading low pressure, but it was only at idle and then only when it dropped below 700ish RPM. Any chance this is normal and the car knows not to fault on these errors? It wont' read them in park, but it will in drive idling and its only sometimes when the rpm drops down.
Mostly - I'm glad there's no light and I don't have bad problems.
High points:
-easiest to get to it while oil filter is out.
-Sensor on the 2.7 is right above oil filter housing it screws in towards the front of the car (plug faces back of the car when installed).
-24mm deep socket for the sensor
-had to drop sway bar (left ends attached)
-had to pull the rubber intercooler(I think that's what it is) hose and steel one (not fun).
-Steel section screws into sump with 2 #5 allens.
Thanks for your help guys.
Oil change/sensor change seems to have fixed it. I ran it for 20+ minutes up and down the road watching the vagcom and 99% of the time it was ok - sensor reading ok. No warning light, got oil up to temperature, probably went about 15 miles mixed in town/highway. Everyonce in awhile looking back through the log it was reading low pressure, but it was only at idle and then only when it dropped below 700ish RPM. Any chance this is normal and the car knows not to fault on these errors? It wont' read them in park, but it will in drive idling and its only sometimes when the rpm drops down.
Mostly - I'm glad there's no light and I don't have bad problems.
High points:
-easiest to get to it while oil filter is out.
-Sensor on the 2.7 is right above oil filter housing it screws in towards the front of the car (plug faces back of the car when installed).
-24mm deep socket for the sensor
-had to drop sway bar (left ends attached)
-had to pull the rubber intercooler(I think that's what it is) hose and steel one (not fun).
-Steel section screws into sump with 2 #5 allens.
Thanks for your help guys.
Thread
Thread Starter
Forum
Replies
Last Post
DirtySanchez
A4 (B5 Platform) Discussion
7
07-16-2002 07:56 AM
S6Erik
A4 (B5 Platform) Discussion
3
12-11-2000 01:59 PM