Aluminium Pedals
#12
I broke one of my studs as well but there are a bunch of them. I'm sure it wouldn't make a difference if I reinstalled it. The dead pedal is a pain to remove and install because it hooks under the kick panel as well as the studs pushed through the carpet.
A dab of white grease on the 2 rubber prongs on the back of the brake pad make it snap onto the pedal easy. Same as the factory does.
Here are the audi ones I installed on my a6.
A dab of white grease on the 2 rubber prongs on the back of the brake pad make it snap onto the pedal easy. Same as the factory does.
Here are the audi ones I installed on my a6.
#13
#18
Got the ebay one for $82.80 shipped and shipping was fast about one week. They are very good quality. I installed them today using the factory instruction.
<a href="http://s162.photobucket.com/user/gotpicz/media/DSC_0264_zps0773f72d.jpg.html" target="_blank"><img src="http://i162.photobucket.com/albums/t267/gotpicz/DSC_0264_zps0773f72d.jpg" border="0" alt=" photo DSC_0264_zps0773f72d.jpg"/></a>
http://autopartspeople.com/audi/inst...l%20Covers.pdf
<a href="http://s162.photobucket.com/user/gotpicz/media/DSC_0264_zps0773f72d.jpg.html" target="_blank"><img src="http://i162.photobucket.com/albums/t267/gotpicz/DSC_0264_zps0773f72d.jpg" border="0" alt=" photo DSC_0264_zps0773f72d.jpg"/></a>
http://autopartspeople.com/audi/inst...l%20Covers.pdf
#19
AudiWorld Member
I did this install over the weekend and unfortunately I botched it. I should have come to this thread and opened the PDF but didn't think installing pedals would have been this difficult and I had done a similar install on my BMW 535 without much of a hitch. This was WAY harder, specially the dead pedal. I pushed the top clip back to get the pedal out and slid the pedal out to remove it, then when I pushed the new one in I about slit my finger in half because the aluminum is super sharp. A razor blade basically. I then pushed the clip back to make it go into the little box but bent it too much and now it's not "holding" everything tight in place and worse, there's a rattle when I go over any non-smooth surfaces. I'm considering following the instructions to uninstall, fix the clip and re-install this. Any other ideas before I spend two hours doing this? not sure I can tighten the clip with the pedal already installed right?
thanks
thanks
Thread
Thread Starter
Forum
Replies
Last Post
Boston Driver
A6 / S6 (C5 Platform) Discussion
33
12-16-2004 12:56 PM