Driver door wiring harness replacement write-up (lots of pics)
#32
Car year
extreme cold the car has been exposed to over here. That is a good point about the fuse, would the control module fuse be found in the fusebox by the driver door? One reason I thought it might be a defective control module is the "intermittent" description found in the DTC. I'll check the fusebox nonetheless. Thanks for the advice.
#34
I just cut all the wires from the door connector and soldered in new wires.
I made a long loop like spring of my new harness inside the door, that went up into the upper door and
then traveled down. I tie wrapped it so the loop stayed sprung.
That way the wire harness is pushed back into the door when I close it and not bent each time the door is closed and the bending is spread out along the inside loop.
Last edited by shurur2; 06-20-2017 at 09:35 PM.
#35
AudiWorld Super User
Doesn't look like it but call ECS and give them your VIN.
https://www.ecstuning.com/Audi-B6_A4.../Door_Harness/
https://www.ecstuning.com/Audi-B6_A4.../Door_Harness/
#36
Doesn't look like it but call ECS and give them your VIN.
https://www.ecstuning.com/Audi-B6_A4.../Door_Harness/
https://www.ecstuning.com/Audi-B6_A4.../Door_Harness/
Found out that they aren't. Not trying to spend $300 on a new harness, so it looks like i'm pulling it from the door and using butt connectors to fix the 7-8 wires that are shot.
Any tips for me?
#37
slide the connector on, twist the wires together, center the connector on the twist and heat it....soldered connection....done.
http://www.ebay.com/itm/50pcs-Waterproof-Solder-Sleeve-Heat-Shrink-Butt-Wire-Splice-Connectors-Terminal-/262616330087
Last edited by shurur2; 06-24-2017 at 08:15 PM.
Thread
Thread Starter
Forum
Replies
Last Post
carl viking
A8 / S8 (D3 Platform) Discussion
36
04-27-2020 01:17 PM
N'Syncro
Parts For Sale - Archive (NO NEW POSTS HERE)
33
02-16-2020 03:12 PM
Touge.ca
Canadian Discussion
0
09-02-2015 01:28 AM