Looking for DIY rear wheel bearing replacement 2001 A4 2.8 quattro
08-05-2014, 06:49 PM
#1
AudiWorld Member
Thread Starter
Join Date: Jan 2006
Posts: 329
Likes: 0
Received 0 Likes
on
0 Posts
Looking for DIY rear wheel bearing replacement 2001 A4 2.8 quattro
that would include all suspension parts removal so that I can bring whole knuckle with hub to my friends machine shop for bearing removal/new bearing installation.
Video of this job would be great.
Thank you.
Video of this job would be great.
Thank you.
08-06-2014, 08:11 AM
#2
AudiWorld Senior Member
08-06-2014, 11:23 AM
#3
Former Vendor
Join Date: Jun 2014
Posts: 136
Likes: 0
Received 0 Likes
on
0 Posts
Hello,
Here is another article I found that should help you get the job done:
AudiWorld Tech Articles
Also, here is the link for the rear bearing if needed:
AutohausAZ - Wheel bearing kit
Disclaimer: Make sure to check the year and model of the vehicle before placing the order.
Here is another article I found that should help you get the job done:
AudiWorld Tech Articles
Also, here is the link for the rear bearing if needed:
AutohausAZ - Wheel bearing kit
Disclaimer: Make sure to check the year and model of the vehicle before placing the order.
08-06-2014, 05:34 PM
#4
AudiWorld Member
Thread Starter
Join Date: Jan 2006
Posts: 329
Likes: 0
Received 0 Likes
on
0 Posts
Thank a lot to both of you guys, great instructions.
I found this great video on youtube where you put one hand on spring and spin the wheel, if you feel anything bearing is bad.
I found this great video on youtube where you put one hand on spring and spin the wheel, if you feel anything bearing is bad.
08-09-2014, 06:47 PM
#5
AudiWorld Member
Thread Starter
Join Date: Jan 2006
Posts: 329
Likes: 0
Received 0 Likes
on
0 Posts
I am stuck on step 12, removed nut from the bolt,but bolt is stuck in bushing.
Tried rubber mallet , no luck. Thinking about getting larger C clamp,mine is only 4 inches diameter.
Any other ideas?
Tried rubber mallet , no luck. Thinking about getting larger C clamp,mine is only 4 inches diameter.
Any other ideas?
Thread
Thread Starter
Forum
Replies
Last Post